Flagler TDF Duct Flange Rollformer

Description

This is a 2009 FLAGLER Model 35-300 14-Station TDF Rollformer with short parts tray in great condition.
Shipping to anywhere in the lower 48-U.S. States is FREE = NO COST TO THE BUYER, call us.
Speed: 60 fpm (optional up to 100 fpm)
Gauge Capacity: 18-26 Gauge Galvanized
1-1/2" dia. (at bearing) Hardened and Ground Spindles
Hardened Feed Gauge
Rise/Fall Short Parts Feeder
7-1/2 HP Drive
Lubrication Points at all Bearings
Extended shafts for Auxiliary Tooling
Shipping Weight: 3,500 lbs.
Shipping Dimensions: 128" long x 32" wide x 40" high
Optional Tooling including but not limited to:
Clip Rolls (20-26 Ga. )
1 ½” Standing Seam Rolls (16-20 Ga. )
1 ¼” Standing Seam Rolls (18-22 Ga. )
1 1/8” Tap-In (3 in 1) (18-22 Ga. )
1/2” Pittsburgh Rolls (16-20 Ga. )
3/8” Pittsburgh Rolls (18-22 Ga. )
5/16” Pittsburgh Rolls (20-26 Ga. )
Options Listed Below must be Factory Installed
1” Standing “S” Cleat, Rolls inboard (22-28 Ga. )
2” x 2” Angle, inboard (16-20 Ga. )
Variable Drive (0-100 fpm)
Short Parts Feeder for Aux Rolls
USED Flagler DF2 Duct Flange Machine #35-200 Includes TDF Duct Flange tooling (18-26 ga.),
rise/fall short parts feeder, extended shafts for auxiliary tooling, hardened feed gauge,
7 1/2 horsepower 230/460 volt 3 phase motor, 60 feet per minute feed rate