Equipment

Stock #: 8398

Type Insulation Cutter Model No. 52″ Width 52″ Length of Cut No limit Capacity (min. – max. blanket thickness) 1/2″ – 2″ Weight Approx. (lbs.) 225 WE HAVE IN STOCK, call us at 800-753-0393

Stock #: 8397

The Engel 1240 Standing S Slip Rollformer is a machine used for roll forming. It has 12 shafts and can form 20-gauge sheet metal into a 1-1/8" bar slip1. The machine is equipped with inboard and ou...

Stock #: 8396

This is a 12' x 3/16" shear that is equipped with 24” Front operated power back gauge, full length treadle trip pedal. Sold as shown in the photos.

Stock #: 8395

This is a Used Wysong Power Rolls 14-16 Ga. Initial pinch power bending roll. Model:B-60 SN:PR18-178 New:1972 Capacity, mild steel:14-16 Ga. Diameter of rolls:4” Motor:1.5 H.P. 230/460/3/60, magnet...

Stock #: 8394

10 gauge x 12 Ft. Accurshear #613512 with Accurveyor Stacker/Conveyor, 48" programmable back gauge, 10' squaring arm, New 2011, #29192

Stock #: 8393

General Specifications Type: Hydraulic Swing Beam Guillotine Shear Model No.: GHS-1040 Capacity: 10 mm (.393701"") Length: 4050 mm (159.4488"", 13') Weight Approx. (Lbs.): 27,000 Electrics: Volt 22...

Stock #: 8392

This is a Right-Hand U Full Engel Coil System with beading, notching, shearing for slip and drive duct as well as for TDF Ductwork. Line is equipped with FIVE (5) 12,000 lb. capacity Coil Cradles, ...

Stock #: 8391

13-stand AG & PBR Panel Rollformer 29 gauge, 36" wide classic rib panel and PBR, cut to any length you need. 5-Ton Auto Decoiler with Cart Set off Table Manual Decoiler THIS UNIT HAS LITERALLY LESS...

Stock #: 8390

This is a 20-gauge Hydraulic Notcher. Notches up to 6 times faster than hand notching. This 5 headed gang notcher is a fast and easy way to notch sheet metal ducting, in preparation to receive bar,...

Stock #: 8389

This is a new 10' x 10-gauge shear that will drop sheared parts to both the front or rear of the shear at 37 strokes per minute. The sheet is held up against the backgauge until sheared and the ope...